green stuff?

by **carvel2** » Fri Mar 02, 2012 9:41 pm

How long before it is fit to paint?

by **Parus Ater** » Fri Mar 02, 2012 9:44 pm

I usually go for 24hours which is likely too long.

by **paulsmodellingworkshop** » Fri Mar 02, 2012 10:09 pm

Usually ok for an undercoat as soon as it has set hard. How long that is will depend on how warm it is...around three hours here.

by **carvel2** » Fri Mar 02, 2012 10:15 pm

@PA...well spotted :lol:

Must resist the oven!!
Must resist the oven.
Must re....
I wonder what temp to set the oven at that wouldnt warp the plastic...
ARRRGGGHHHHHH!!!!

by **Stuart** » Fri Mar 02, 2012 10:15 pm

As I've only been using it on small areas, I've been doing it before I go out to work in the morning that way it's dry and ready when I get back. But I have painted over it after about four hours and that was fine.

by **carvel2** » Fri Mar 02, 2012 10:20 pm

http://www.youtube.com/watch?v=aDnTo2S2BrA&feature=endscreen&NR=1

by **gorgarrak** » Fri Mar 02, 2012 11:28 pm

4 hours to paint over, 6 to sculpt over, but you could always use a putty oven.

green stuff?

green stuff?

Re: green stuff?

Re: green stuff?

Re: green stuff?

Re: green stuff?

Re: green stuff?

Re: green stuff?

Who is online